All-Pro 2010 Film
Processor
Isn't it time to take
a look at the latest film processing system from All-Pro Imaging?
The All-Pro 2010® is the
next generation of film processors from All-Pro Imaging. Like its predecessor,
the 2000M, the All-Pro 2010 consistently delivers high quality 8"x10" and 10x12"
x-rays quickly and automatically.
The All-Pro 2010's microprocessor takes the guesswork out of film processing by
accurately controlling time, temperature and chemistry strength, the keys to
consistent film quality.
Two user-selectable speeds allow the processing of all types of x-ray films. The
efficient warm air dryer ensures that films are delivered completely dry to
allow immediate reading and diagnosis.
| Electrical: |
115 Vac, 60 Hz, 10
amps. Use a 15 amp, 3 prong, grounded outlet.
A separate dedicated 15 AMP line is recommended. |
| Water Flow: |
1/2 gallon per
minute water flow (while processing film). |
| Water Pressure |
80 PSI maximum/30
PSI minimum. Water source must have a manual shut-off near processor. |
| Water Connection: |
Valved 3/4" male
garden hose fitting near rear of processor.
6' hose with standard female garden hose fittings provided. |
| Water Backflow
Prevention: |
A vacuum breaker is
not normally required. The processor has a 1" air gap between water supply
inlet and maximum water level height. |
| Water Temperature: |
55°F (13°C) to 85°F
(29.5°C). |
| Drain: |
1 1/2" vertical PVC
standpipe, open at top. DO NOT DRAIN INTO COPPER OR BRASS. The top of the
standpipe must be 6" below the bottom of the countertop. |
| Dimensions: |
18" (H) x 15" (W) x
25" (D) with leveling base. |
| Weight: |
90 lbs. with water
and chemistry (75 lbs. empty) |
| Ventilation: |
Room temperature
must be below 85°F (29.5°C) during processing. Because heat is generated
during processing, adequate ventilation is required to maintain darkroom
temperature. 8-12 volume room air changes per hour recommended. |
